How to Resolve - After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it...? ~ How to Fix Dll Not Found Error?

Monday, 18 April 2016

How to Resolve - After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it...?

After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it...

I have a HP Compaq 6720s...
Windows 7 Professional X 64bit
My specs are :

Intel Core 2 Duo
2X2GB DDR3
1X120GB FUJITSU Hard Drive
Intel X3100 Graphics Media Accelerator
Intel PRO Wireless 3945 ABG

Before I enabled it, it took about 40 ( 5 secs stall on HP logo ) secs to boot, now it takes about 1 min and 30 sec to boot ( stalls for about 30 secs on the HP logo )...
WTF did microsoft do to my PC??? I dont want to restore my PC again because I have a lot of data and that I have already restored Windows 7 Pro alone on this PC 8 times and I learnt somewhere that restoring it too much is bad for a old hard drive like
mine.

Anwsers to the Problem After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it...

Download Error Fixer for Free Now

Hi,
What made you to remove maximum memory setting in msconfig?

Let’s try the troubleshooting steps mentioned below:

Method 1: Open the Performance troubleshooter
http://windows.microsoft.com/en-us/windows7/Open-the-Performance-troubleshooter

Method 2: Boot the computer in safe mode and check whether the issue persists, if the issue does not persist then perform clean boot and check whether the issue resolves.

Safe mode starts Windows with a limited set of files and drivers.
Startup programs don't run in safe mode, and only the basic drivers needed to start Windows are installed.
Please click on the mentioned link below.

http://windows.microsoft.com/en-US/windows-vista/Start-your-computer-in-safe-mode

Method 3: To help troubleshoot error messages and other issues, you can start Windows by using a minimal set of drivers and startup programs.
This kind of startup is known as a "clean boot." A clean boot helps eliminate software
conflicts.

Note When you perform a clean boot, you may temporarily lose some functionality.
When you start the computer as usual, the functionality returns.
However, you may receive the original error message, or you may experience the original
behavior.

Note: Follow step 7 to reset the computer to start as usual after the clean boot process.

http://support.microsoft.com/kb/929135

Refer: Optimize Windows 7 for better performance
Click on the link mentioned and check if it helps.
http://windows.microsoft.com/en-us/windows7/Optimize-Windows-7-for-better-performance

Hope it helps.

Open Action Center by clicking the Start button Picture of the Start button, clicking Control Panel, and then, under System and Security, clicking Review your computer's status.

Make sure your computer has at least the minimum amount of random access memory (RAM) required to run the program that is displaying the error. Look for the program requirements online or in the packaging information.

Recommended Method to Fix the Problem: After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it...:

How to Fix After Removing Maximum Memory in MSCONFIG, The boot is not as fast before I first enabled it... with SmartPCFixer?

1. You can Download Error Fixer here. Install it on your system. When you open it, it will perform a scan.

2. After the scan is done, you can see the errors and problems which need to be fixed.

3. The Fixing part is done, the speed of your computer will be much higher than before and the errors have been removed.

How to Fix Dll Not Found Error?

Monday, 18 April 2016